BMW 2004 525i Sedan Manual Do Proprietário

184

The onboard tool kit is located in the lug-
gage compartment lid. 

Loosen the wingnut to open.

To replace, fold the wiper arm up and hold. 
Press the catches together while pushing 
the wiper blade out of the front. 

The lamps and bulbs are essential factors 
contributing to the safety of your vehicle. 
Therefore, comply fully with the following 
instructions during bulb replacement. If you 
are not familiar with the specified proce-
dures, have the replacements carried out at 
your BMW center.

Never touch the glass of new bulbs 
with your bare fingers, as even minute 

amounts of contamination will burn into the 

bulb's surface and reduce its service life. 
Use a clean cloth, napkin, etc., or hold the 
bulb by its metal socket.
In the case of bulbs where the replacement 
is not described, please consult your BMW 
center.

<

You can obtain a selection of replacement 
bulbs at your BMW center.

To prevent short circuits, before 
working on any electrical system, 

equipment or accessory you should always 
switch it off and disconnect the cable from 
the battery's negative terminal before start-
ing.
To avoid possible injury or equipment dam-
age when changing bulbs, observe any 
instructions provided by the bulb manufac-
turer.

<

When maintaining the headlamps, 
please comply with the instructions in 

the separate Caring for your vehicle bro-
chure.

<

The illustration shows the left-hand side of 
the engine compartment.

Cover cap for low beams 

Cover cap for high beams

Turn the cover cap to the left and remove.

Always wear gloves and eye protec-
tion – the atmosphere within the H7 

bulb is pressurized. Failure to observe this 
precaution can lead to personal injury 
should the bulb be damaged.

<

Online Edition for Part No. 01 41 0 157 647 - © 07/03 BMW AG