BMW 2004 525i Sedan Manual Do Proprietário
49
Driving
Ignition lock
0 Steering locked
The key can only be inserted or removed in
this position.
this position.
After removing the key, turn the steering
wheel slightly until it locks.
wheel slightly until it locks.
Vehicles with automatic transmission:
only move the selector lever from
only move the selector lever from
position P with the engine running. To turn
the key back to position 0 or to remove it,
first place the selector lever in position P:
Interlock.
the key back to position 0 or to remove it,
first place the selector lever in position P:
Interlock.
<
1 Steering unlocked
A slight steering wheel movement often
makes it easier to turn the key from 0 to 1.
makes it easier to turn the key from 0 to 1.
Individual current consumers are ready for
operation.
operation.
2 Ignition switched on
All vehicle systems are ready for operation.
3 Start engine
Starting the engine
Do not run the engine in closed
rooms, as otherwise the inhaling of
rooms, as otherwise the inhaling of
toxic exhaust gases can cause uncon-
sciousness and death. The exhaust gases
contain carbon monoxide, an odorless and
colorless, but highly toxic gas. Never leave
an unattended vehicle with the engine run-
sciousness and death. The exhaust gases
contain carbon monoxide, an odorless and
colorless, but highly toxic gas. Never leave
an unattended vehicle with the engine run-
ning, as such a vehicle represents a poten-
tial safety hazard.
tial safety hazard.
<
Do not allow the engine to warm up by
leaving it running while the vehicle remains
stationary. Instead, begin to drive immedi-
ately at a moderate engine speed.
leaving it running while the vehicle remains
stationary. Instead, begin to drive immedi-
ately at a moderate engine speed.
When starting the engine, do not press the
accelerator pedal.
accelerator pedal.
Your BMW is equipped with the con-
venience starting feature. Here, it is
venience starting feature. Here, it is
sufficient to turn the ignition key only briefly
to position 3 'Start engine' and to let go of it
right away. The system responds by auto-
matically engaging the starter for a certain
period and allowing it to run until the engine
starts, after which it then disengages auto-
matically. The automatic starting mode will
not operate or will be canceled if the bat-
tery voltage is low. The engine can be
started by jump-starting, refer to
page
to position 3 'Start engine' and to let go of it
right away. The system responds by auto-
matically engaging the starter for a certain
period and allowing it to run until the engine
starts, after which it then disengages auto-
matically. The automatic starting mode will
not operate or will be canceled if the bat-
tery voltage is low. The engine can be
started by jump-starting, refer to
page
<
Press the accelerator pedal halfway down
when starting if
when starting if
>
the engine fails to start on the first
attempt, for instance, if it is very hot or
cold
attempt, for instance, if it is very hot or
cold
>
the engine is started at very low tem-
peratures, as of approx. +5 7/–156,
at high altitudes over approx. 3,300 ft/
1,000 m.
peratures, as of approx. +5 7/–156,
at high altitudes over approx. 3,300 ft/
1,000 m.
Avoid frequent starting in quick suc-
cession or repeated start attempts in
cession or repeated start attempts in
which the engine does not start. Otherwise,
the fuel is not burned or inadequately
burned and there is a danger of overheat-
ing and damaging the catalytic converter.
the fuel is not burned or inadequately
burned and there is a danger of overheat-
ing and damaging the catalytic converter.
<
Manual transmission
1.
Apply the handbrake
2.
Gearshift lever in idle position
3.
Press the clutch pedal
4.
Start the engine.
Before leaving the vehicle with the
engine running, place the gearshift
engine running, place the gearshift
Online Edition for Part No. 01 41 0 157 647 - © 07/03 BMW AG