After parking the vehicle and switching off
the headlamps, operating the headlamp
flasher activates the low beams. You can
set the duration using the Control Center or
deactivate the function.

Control Center, for principle details, refer to
page

Open the menu

Select "Vehicle settings" and press the
controller

Select "Lighting" and press the control-
ler

Select "Pathway lighting" and press the
controller

Turn the controller to select the corre-
sponding duration

Press the controller to apply the setting.

Lights on warning

If you turn the ignition key to position 0, an
acoustic signal sounds when you open the
driver's door for a few seconds to remind
you that the light has not yet been switched
off. At the same time a message appears
on the Control Display.

Daytime driving lamps*

If desired, the light switch can remain in the
low beam position:
When you switch off the ignition, the exte-
rior lighting goes out.

Always observe all applicable laws govern-
ing the use of daytime driving lamps.

You can switch on the parking lamps when
needed using the standard procedure
described under Parking lamps.

Automatic headlamp control*

When you set the switch to this
position, the system activates and
switches on and off the low beams

in response to changes in ambient light
conditions, for instance, in a tunnel, at
dawn and dusk, and in rain and snow. The
LED next to the symbol is illuminated when
the low beams are on.