Brother CS-8150 Manual Do Proprietário
15
1
e
Pull the trailing thread through the slot, down
and to the left, as shown below, until it enters
the delivery eye under the tension spring.
and to the left, as shown below, until it enters
the delivery eye under the tension spring.
a
Tension spring
f
Hold the bobbin case by the latch, fully insert
the bobbin case into the shuttle race, and then
release the latch.
• Make sure the bobbin case finger fits into the
the bobbin case into the shuttle race, and then
release the latch.
• Make sure the bobbin case finger fits into the
notch at the top of the shuttle race.
a
Bobbin case finger
b
Notch
g
Close the shuttle cover.
● Make sure that the bobbin case is properly
placed back into the machine. If it is incorrectly
installed, it will fall out from the shuttle when the
machine starts to sew.
installed, it will fall out from the shuttle when the
machine starts to sew.
CAUTION
LS2125_01.fm Page 15 Thursday, February 28, 2008 11:08 AM