Beckett AFII Manual Do Utilizador
12
Figure 8a. – Interrupted ignition, valve-on delay only
(no motor-off delay)
(no motor-off delay)
Figure 8b. – Interrupted ignition, valve-on delay and
motor-off delay
motor-off delay
SAFETY AND
OPERATING
LIMITS
LIMIT
L1
L2 (VLV)
VALVE
L2
MOTOR
L2 (MTR)
L2 (IGN)
IGNITER
CAD
CELL
CELL
MOTOR
IGNITER
W
R
80
70
60
50
50
70
80
60
OIL VALVE
CAD CELL
THERMOSTAT
TR
TW
TR-TW
JUMPER
TR-TW TERMINALS
LOCATED ON OPPOSITE
SIDE OF CONTROL
L1
L2
L2
SAFETY AND
OPERATING
LIMITS
LIMIT
L1
L2 (VLV)
VALVE
L2
MOTOR
L2 (MTR)
L2 (IGN)
IGNITER
CAD
CELL
CELL
MOTOR
IGNITER
W
R
80
70
60
50
50
70
80
60
OIL VALVE
CAD CELL
THERMOSTAT
TR
TW
TR-TW
JUMPER
TR-TW TERMINALS
LOCATED ON OPPOSITE
SIDE OF CONTROL
L1
L2
L2
LIMIT
L1 - LIMIT
JUMPER
JUMPER
Table 2 - Reset Button Operation
If the burner is in the
below state:
Pushing the reset button will:
Button Click
(press < 1 second)
Button Hold
(press > 1 second)
Button Hold
(press 15+ seconds)
Lockout
Reset from Soft Lockout
Reset from Restricted (Hard)
Lockout
Lockout
Valve-on Delay, Trial for
Ignition, Ignition Carryover
Ignition, Ignition Carryover
Go to Pump Prime (see
“Priming the Pump” above)
“Priming the Pump” above)
Disable the Burner:
Any time the burner is running,
press and hold the reset button
to disable the burner. The
burner will remain off as long
as the button is held.
Any time the burner is running,
press and hold the reset button
to disable the burner. The
burner will remain off as long
as the button is held.
Enables Pump Priming:
After the reset button has been
held for 15 seconds, the button
can then be clicked during the
next ignition sequence to enter
Pump Prime mode.
After the reset button has been
held for 15 seconds, the button
can then be clicked during the
next ignition sequence to enter
Pump Prime mode.
Run (igniter is shut off)
No action
Motor-Off Delay,
Standby
Standby
No action
Pump Prime
No action
Exit Pump Prime mode and return to Standby
Table 3 - Status Lights
Light Color
On Continuously
Flashing
Red
Restricted (Hard) Lockout
Soft Lockout
Green
Flame Sensed during normal operation (Could
be stray light during standby)
be stray light during standby)
Recycle
Yellow
Control is in Pump Prime mode or
Reset button currently held for 15+ seconds.
Reset button currently held for 15+ seconds.
N/A
Reset Button Operation
Table 2 explains what action the control will take when the reset button is pressed for different lengths of time during
the various burner operating states.
the various burner operating states.
Section: Burner Controls