Broadband Products AMC-6 Manual Do Utilizador

 
 
 
 
 
 

To install the external USB satellite modem, do the following steps. There’s no need to turn off the 
computer at this time. 
1. Connect the power cord, one end to the power outlet, the other to the DC IN connector on the back 
of the external USB satellite modem.  
2.  Connect the external USB satellite modem cable, one end to the USB port on the PC. DO NOT 
connect the other end to the USB port on the back of the external USB satellite modem yet.  
3. Connect the coaxial cable from the satellite dish to the female plug on the TechniSat modem you 
just installed. 
 
 

 
(*The PCI and USB drivers are located on the CD supplied with your B2C2 satellite modem. It is 
necessary to install the modem and drivers prior to installing the satellite software) Our drivers 
support Windows XP and Windows 2000 Professional. The procedure for the driver installation for the 
Internal PCI satellite modem and the External USB satellite modem are the same. If installing the 
External USB satellite modem drivers, plug in the USB cable into the back of the B2C2 satellite 
modem at this time. 
 
 

To install the B2C2 satellite modem driver on Windows XP, you must be logged on as an 
Administrator or have Administrator Privileges. 
 

1.  When you start your computer for the first time after installing the B2C2 internal PCI satellite 

modem, or after plugging in the external B2C2 USB satellite modem, the Plug-N-Play feature 
should recognize the new modem installed (Figure 2-1). 

 

 

Figure 2-1 

5