Black Diamond Indoor Fireplace Black Diamond Burner Kit Manual Do Utilizador
TC30.NGO3.C 100308
3
A porcelain panel set must be used in conjunction with the installation of the burner
assembly. See Installation and Operating Instructions manual for details.
assembly. See Installation and Operating Instructions manual for details.
1. Remove three screws from the rear of
the fi rebox. Attach the manifold bracket
to the rear of the fi rebox with the three
screws previously removed. (Fig. #1)
to the rear of the fi rebox with the three
screws previously removed. (Fig. #1)
2. Attach the manifold supply tube to the
bulk head fi tting and tighten. (Fig. #2)
Ensure that there are no leaks.
Ensure that there are no leaks.
3. Attach the pilot supply tube to the bulk
head fi tting and tighten. (Fig. #3) Ensure
there are no leaks.
there are no leaks.
4. Attach spark electrode (ORANGE) and
sensor leads to the electrical bulk head.
(Fig. #4)
(Fig. #4)
(The spark electrode connection is the
rearmost connector.)
rearmost connector.)
NOTE:
If unit is to be converted to Propane, see Propane conversion instructions on
page 7 before proceeding.
If unit is to be converted to Propane, see Propane conversion instructions on
page 7 before proceeding.
NOTE: Plug the 4 vacant holes in the bottom of the fi rebox with 1/2” screws,
as they are not required to attach this style of burner.
as they are not required to attach this style of burner.
Black Diamond Burner Installation
INSTALL MANIFOLD ASSEMBLY
Fig #1
Fig #2
Fig #3
Fig #4
ATTACH MANIFOLD SUPPLY TUBE
ATTACH PILOT SUPPLY TUBE
ATTACH SPARK ELECTRODE
AND SENSOR LEADS
AND SENSOR LEADS