Bags and Gloves E-9220T Manual Do Utilizador
39
www.gateway.com
Installing drives
■
IDE drives can be configured as master, slave, or cable-select.
■
If cable-select is available (drive assignments will be marked on the cable), the
IDE cable assigns the master/slave positions to the drives it connects. You can
override these assignments using the jumpers on the drives.
IDE cable assigns the master/slave positions to the drives it connects. You can
override these assignments using the jumpers on the drives.
■
If cable-select is not available and only one drive is attached to an IDE controller
cable, configure the drive as master if it is a CD or DVD drive. If two drives of
any type are attached to the cable, configure one as master and one as slave.
cable, configure the drive as master if it is a CD or DVD drive. If two drives of
any type are attached to the cable, configure one as master and one as slave.
■
You may need to configure the drives you install using the BIOS Setup utility. Press
F2 at startup to open the BIOS Setup utility.
F2 at startup to open the BIOS Setup utility.
Installing or replacing a fixed or removable-media drive
Use these instructions to install or replace a diskette, CD, DVD, hard drive, or tape drive.
To install a drive in an external drive bay:
1
Follow the instructions in
.
2
Follow the instructions in
3
If you are replacing a CD, DVD, or diskette drive, go to
, otherwise follow the
instructions in
4
If you are adding a new drive to an available drive bay, remove the EMI shield from
the bay by pulling the assembly out of the bay.
the bay by pulling the assembly out of the bay.
EMI shield