Bags and Gloves E-9220T Manual Do Utilizador

www.gateway.com

Troubleshooting

Try these steps first before going to the following sections:

■

Make sure that the power cords are connected to your server and an AC outlet and 
that the AC outlet is supplying power.

■

If you use a UPS, make sure that it is turned on and is rated to handle the power 
required by your server.

■

If you added or removed server components before the problem started, review 
the installation procedures you performed and make sure that you followed each 
instruction. You may need to remove the device, uninstall the device’s software, 
then reinstall the device.

■

If an error message appears on the screen, write down the exact message before 
calling Gateway Customer Care.

■

Restart your server, then open the BIOS Setup utility by pressing and holding F2 
while your server restarts. Check your configuration settings.

■

If an error occurs in a program, see its documentation or online help.

If you have problems after installing a new CMOS battery, try each of the following items, 
closing the case and restarting the server after each try:

■

Restart your server, then open the BIOS Setup utility by pressing and holding F2 
while your server restarts. Correct any discrepancies.

■

Remove the side panel by following the instructions in 

, then make sure that all cables inside the case are attached securely. 

Also, make sure that the colored cable edges are aligned correctly and that the 
connectors do not miss any pins.

To avoid bodily injury, do not attempt to troubleshoot your server 
problem if:

■

Power cords or plugs are damaged

■

Liquid has been spilled into your server

■

Your server was dropped

■

The case was damaged

Instead, unplug your server and contact a qualified computer 
technician. If your server was damaged during shipment from 
Gateway, contact Gateway Customer Care.