Woodstock SHOP FOX W1668 Manual Do Utilizador

-

9

-

While the main components of the Shop Fox

®

W1668 Oscillating Drill Press are assembled at the factory,

some assembly is required. The following is the recommended sequence best suited for final assembly.

TOOLS REQUIRED: You will need a 10mm, 12mm and 14mm open end wrench, a flat tipped screwdriv-
er, a Phillips

®

screwdriver (not supplied) and a 3mm, 4mm and 5mm Allen

®

wrench (supplied).

Ensure machine is unplugged before begin-
ning assembly!

Place base on a stable work bench. Make
sure the work bench will handle the weight
of the drill press and workpiece.

It is recommended that the base be secured
to the bench. Otherwise a tipping hazard
will exist.

Clamp the base to the table once a suitable
location is found. Use 

5

⁄

16

" lag bolts or

through bolts with washers, lock washers
and nuts. Use the mounting holes in the
base as a drill guide. Figure 7.

Place the column on the base and line up
the 4 mounting holes. Secure tightly with
the M10-1.5 x 25mm hex head bolts using
open end wrench provided. 

Figure 7. Using holes in base as drill guide.

The two-piece dust port is assembled to the bot-

tom of the table using the four M4- 0.7 x 22mm
Phillip

®

head screws. Figure 8.

Figure 8. Installing the dust port.