Woodstock SHOP FOX W1668 Manual Do Utilizador

-

13

-

Three handles are supplied with your new

Oscillating Drill Press. Thread them into the hub
as in Figure 20.

Figure 20. Spindle handle installation.

Figure 19. Securing drill chuck with screw.

Figure 18. Jaws adjusted inside chuck body.

The drill chuck is attached to the drill spindle by
means of matched tapers and screw. To mount
the drill chuck to the spindle, carefully follow
the instructions below:

1.  The drill chuck and spindle must be thor-

oughly cleaned before assembly. It is rec-
ommended that mineral spirits be used for
this task. Refer to the safety warnings on
the container. Failure to clean the mating
surfaces may result in separation and wear.

Use the chuck key provided to adjust the
jaws of the chuck until they are well inside
the drill chuck body. Figure 18.

3.  Place the drill chuck on the spindle. Insert

the Allen

®

head cap screw into the hole of

the drill chuck as in Figure 19. Tighten the
screw.  The drill chuck should be seated
securely on the spindle at this time and
should be checked for looseness. If the
chuck fails to remain secure on the spindle,
repeat step 1 and 2.