Woodstock SHOP FOX W1668 Manual Do Utilizador
-
16
-
Oscillating Feature
One of the great features of the W1668 Drill
Press is its capability for oscillating sanding. The
drill press can be converted from drilling opera-
tions to sanding operations in just a few steps.
Press is its capability for oscillating sanding. The
drill press can be converted from drilling opera-
tions to sanding operations in just a few steps.
1.
Unplug the drill press and remove the
spindle handles.
spindle handles.
2.
Install the round rubber belt onto the top
groove in the spindle pulley and the oscil-
lating pulley located between the idler pul-
ley and the spindle pulley. The belt will
stretch for this purpose. Figure 22.
groove in the spindle pulley and the oscil-
lating pulley located between the idler pul-
ley and the spindle pulley. The belt will
stretch for this purpose. Figure 22.
4.
Remove the 3 spindle handles. If left in
place, the operator may be struck by them
while the spindle travels up and down.
place, the operator may be struck by them
while the spindle travels up and down.
3.
Close the cover. The motor will not start
until the cover is closed.
until the cover is closed.
4.
Loosen the knob for depth stop.
If the depth stop is left adjusted for a shallow
hole, damage will occur to the oscillating
mechanism. Check and adjust depth stop
before using oscillating feature.
hole, damage will occur to the oscillating
mechanism. Check and adjust depth stop
before using oscillating feature.
Figure 26. Stretch the belt to fit on pulleys.