Alpine CDA-9812RB Manual Do Utilizador

-EN

Detaching and Attaching the Front Panel

Detaching

Turn off the unit power.

Press

(Release) at the upper left side until the

front panel pops out.

Grasp the left side of the front panel and pull it out.

• The front panel may become hot in normal usage (especially the

connector terminals on the back of the front panel.) This is not a
malfunction.

• To protect the front panel, place it in the supplied carrying case.

Attaching

Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.

Push the left side of the front panel until it locks
firmly into the main unit.

• Before attaching the front panel, make sure that there is no dirt or

dust on the connector terminals and no foreign object between the
front panel and the main unit.

• Attach the front panel carefully, holding the sides of the front panel

to avoid pushing buttons by mistake.

Changing the Audio Level Display Pattern
(CDA-9815RB/CDA-9813R/CDA-9812RX only)

You can select the Audio Level display from three display patterns.
You can also deactivate the display.

Press DISP/B.OUT to switch the display pattern.

For CDA-9815RB/CDA-9813R:

AUDIO ADJUSTMENT

→ EQ ADJUSTMENT → X-OVER

ADJUSTMENT

→ OFF → AUDIO ADJUSTMENT

For CDA-9812RX:

AUDIO ADJUSTMENT

→ BASS ADJUSTMENT → TREBLE

ADJUSTMENT

→ OFF → AUDIO ADJUSTMENT

The indicators show the value that is set in each mode as
shown below.

AUDIO

EQ/BASS/TREBLE

X-OVER

ADJUSTMENT

Level
Indicator

Width
indicator

Frequency
Indicator

Sub-W
Indicator

∗Only when SUB-W is set to ON

AUDIO Adjustment Display
Example for CDA-9813R

VOLUME

: 18

BALANCE : L6

FADER

: F6

SUB-W

: 9dB

EQ Adjustment Display

Example for CDA-9813R

LEVEL

: +2

WIDTH

: 2

FREQUENCY: 200Hz

VOLUME

BALANCE

FADER

SUB-W∗

LEVEL

WIDTH

FREQUENCY

LEVEL

SLOPE

FREQUENCY

X-OVER Adjustment Display

Example for CDA-9813R

LEVEL

: -7dB

SLOPE

: 2 (-12dB/oct)

FREQUENCY : 2k