Woodstock SHOP FOX W1667 Manual Do Utilizador

-14-

Figure 20. Typical spring cover lock slot and

locking lug.

Figure 18. Feed shaft return spring assembly.

Figure 19. Quill shaft fully seated.

The feed shaft return spring is adjusted at the fac-

tory; however, during the life of the drill press you
may want to adjust the feed shaft return spring at
a stronger return pressure.  

Wipe off any oil on the spring lock cover so
it will not slip in your fingers when you hold
the cover from spinning. See 

3.  Make sure the quill shaft is completely seat-

ed  and the depth stop reads “0”. See 

4.  Put on thick leather gloves and hold the

spring cover against the side of the head-
stock so the cover stays splined with the
locking lug; remove the jam nut and loosen
the cover nut approximately  

1

⁄

4

" (6.4mm).

See 

5.  Pull the cover outward just enough to dis-

engage the spring-cover lock slot from the
locking lug. See 

6.  Rotate the cover counter clockwise to

increase spring tension, or let the cover
slowly unwind in the clockwise direction to
reduce spring tension. See