Woodstock SHOP FOX W1667 Manual Do Utilizador

Choose the insert that has an opening
which is slightly bigger than the sanding
drum chosen. See 

Insert the sanding drum mandrel into the
chuck and set the chosen table insert into
the pocket in the top of the table. See
Figure 40.

• For general drill bits, small reamers, and

miscellaneous small cutting and sanding
bits, use the 

5

⁄

8

'' and the 1'' table inserts.

• For the 1'' sanding drum, use the 1 

3

⁄

8

''

table insert.

• For the 1 

1

⁄

2

'' sanding drum, use the 1 

7

⁄

8

''

table insert.

• For the 2'' sanding drum, use no table

insert.

Loosen and pivot the table so the opening
in the installed table insert is centered to
the drill bit or sanding drum. 

10. Adjust the table height to use all of the

grit on the paper as the paper wears. 

• If the thickness of the workpiece does not

allow much table movement and the
sanding drum paper is partially worn on
one end, remove the drum from the sand-
ing spindle, turn it end for end and
replace it on the sanding spindle to use
the newer part of the sandpaper. 

11. Turn the drill press 

ON, and begin sanding.

Figure 39. Sanding drum table insert.

Figure 40. Sanding drum installed.

-24-