White Outdoor 769-04211 Manual Do Utilizador

IMPORTANT: The snow thrower is shipped with oil 
and WITHOUT GASOLINE. After assembly, refer to 
separate engine manual for proper fuel and engine oil 
recommendations.
1.  Observe the lower area of the snow thrower to be sure 

both cables are aligned with roller guides. 
a.  Pull up and back on upper handle as shown in 

Figure 3-1. Align upper handle with the lower 
handle. 

b.  Tighten hand knobs securing upper handle to 

lower handle.

2.  Remove wing nut and hex screw from chute control 

assembly and clevis pin and cotter pin from chute 
support bracket. See Figure 3-2. Position the chute 
assembly (forward-facing) over the chute base. 

3.  Place chute assembly onto chute base and secure 

chute control assembly to chute support bracket with 
clevis pin and cotter pin removed earlier. See Figure 
3-3.

4.  Finish securing chute control assembly to chute 

support bracket with wing nut and hex screw removed 
earlier. See Figure 3-4.

5.  Check that all cables are properly routed through the 

cable guide. See Figure 3-5.

NOTE: References to 
right or left side of the 
snow thrower are deter-
mined from behind the 
unit in the operating 
position.

NOTE: Two replace-
ment auger shear pins 
are included with this 
manual (or stowed 
in the plastic handle 
panel). Refer to Augers 
in the Maintainance 
Section for more 
information regarding 
shear pin replacement.

NOTE: This Operator’s 
Manual covers several 
models, handle panels, 
lights and chute cranks 
are some features that 
may vary by model.  
Not all features refer-
enced in this manual 
are applicable to all 
snow thrower models.