White Outdoor 450 Manual Do Utilizador

NOTE:  References to right or left side of the tiller are 

determined from behind the unit in the operating position.

•  Remove staples, break glue on top flaps, or cut tape 

at carton end and peel along top flap to open carton.

•  Remove loose parts included with unit (i.e., 

operator’s manual, etc.).

•  Cut corners and lay carton down flat.
•  Remove packing material.
•  Roll or slide unit out of carton. Check carton 

thoroughly for loose parts.

•  Extend control cable and lay on the floor. Be careful 

not to bend or kink control cable.

IMPORTANT:  This unit is shipped without gasoline 

or oil in the engine. Be certain to service engine with 

gasoline and oil as instructed in the separate engine 

manual before operating your machine.

•  Depth Stake
•  Handle Assembly
•  Shift Rod

NOTE:  All hardware needed for assembly is attached 

to the loose parts or the tiller.

•  Tip the tiller forward so it rests on front counterweight.
•  Unthread the “T” knob from the top of the depth stake 

and remove the flat washer and hex bolt. Remove the 

hairpin clip from the clevis pin. See Figure 1.

•  Raise the tine shield hinge flap assembly and insert 

the depth stake assembly in the slot (under the tine 

shield) and up through the tine shield assembly.

•  Insert clevis pin through the tine shield and depth 

stake assemblies. Secure with hairpin clip.

•  Insert a hex bolt into top hole of the depth stake 

assembly. Place flat washer on the hex bolt and thread 

“T” knob onto the hex bolt. Tighten securely.  

See Figure 1.

•  Tip the tiller back down so it rests on the tines.

•  Remove top two bolts and flange lock nuts from 

handle mounting brackets, but do not remove the 

bottom bolt and nut. See Figure 2.

•  Place handle assembly in position between the 

handle mounting brackets.

•  Line up holes in handle with holes in bracket and 

secure with hardware previously removed.

Attach the clutch cable to the handle as follows: 

(be careful not to kink the cable)