Whirlpool WFW9151YW Instrução De Instalação

Loosen bolts with a 13 mm (1/2") wrench.  

Slide each bolt and spacer to center of hole. Pull bolts and 

plastic spacers from back of washer. Save transport bolts 

and spacers. Contact a qualified servicer if washer is to be 

transported.

Close bolt holes on cabinet back with transport bolt hole plugs 

included with washer parts.

Pull power cord through opening in rear panel and close  

holes (2) with attached white plastic cap.

 If washer is transported at a later date, call a certified 

technician to properly set up washer for relocation, to avoid 

suspension and structural damage.

Gently place power cord over top of washer to allow free 

access to back of washer.

Squeeze hose clamp tabs with pliers and slide over end of 

drain hose. Slide drain hose onto washer elbow connector 

and secure with clamp.

For a laundry tub or standpipe drain, go to step 8. 

You may need additional parts with separate directions.  

See Floor drain system under “Alternative Parts”.