Whirlpool WFW9151YW Instrução De Instalação

q

  Check electrical requirements. Be sure you have correct  

electrical supply and recommended grounding method.

q

  Check that all parts supplied are now installed. If there is an 

extra part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Check that transport bolts and plastic spacer materials were 

completely removed from back of washer.

q

  Check that both hot and cold hoses are attached and water 

faucets are on.

q

  Check for leaks around faucets, valves, and inlet hoses.

q

  Remove protective film, tape, or any packaging material 

remaining on washer.

q

  Check that washer is plugged into a grounded 3 prong  

outlet.

q

  Dispose of/recycle all packaging materials.

q

  Read “Using Your Washer” in your Washer Use and Care 

Guide.

q

  To test and clean your washer, press POWER and choose  

the NORMAL cycle and run it without clothes. Use only HE 

detergent. Use 1/2 the manufacturer’s recommended amount 

for a medium-size load.

If washer is not level, use a 9/16" or 14 mm open-end or  

adjustable wrench to turn jam nuts clockwise on feet until they 

are about 1/2" (13 mm) from the washer cabinet. Then turn the 

leveling foot clockwise to lower the washer or counterclockwise 

to raise the washer. Recheck levelness of washer and that all 

four feet are firmly in contact with the floor. Repeat as needed.

HELPFUL TIP: You may want to prop up front of washer 

about 4" (102 mm) with a wood block or similar object that  

will support weight of washer.

When washer is level and all four feet are firmly in contact with 

the floor, use a 9/16" or 14 mm open-end or adjustable wrench 

to turn jam nuts counterclockwise on leveling feet tightly 

against washer cabinet. 
HELPFUL TIP: You may want to prop washer again with a 

wooden block.

Raise

Washer

Lower

Washer

Jam nut

Jam nut