Whirlpool W10044940 Manual Do Utilizador

If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrical installer determine that 
the ground path and wire gauge are in accordance with local 
codes.
Check with a qualified electrical installer if you are not sure the 
range is properly grounded.
This range must be connected to a grounded metal, permanent 
wiring system.
Be sure that the electrical connection and wire size are adequate 
and in conformance with the National Electrical Code, ANSI/NFPA 
70-latest edition or CSA Standards C22.1-94, Canadian Electrical 
Code, Part 1 and C22.2 No. O-M91-latest edition, and all local 
codes and ordinances.

A copy of the above code standards can be obtained from:

 National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

To properly install your range, you must determine the type of 
electrical connection you will be using and follow the instructions 
provided for it here.

■

Range must be connected to the proper electrical voltage and 
frequency as specified on the model/serial number rating 
plate. The model/serial number rating plate is located at the 
bottom of the right-hand mounting rail. See the following 
illustration.

■

Models rated from 12.7 kW at 240 volts (9.5 at 208 volts) 
require a separate 50-amp circuit.

■

A time-delay fuse or circuit breaker is recommended.

■

Flexible cable from appliance should be connected directly to 
the junction box.

■

Fuse both sides of the line.

■

Do not cut the conduit. The length of conduit provided is for 
serviceability of the oven.

■

A UL listed or CSA approved conduit connector must be 
provided.

■

If the house has aluminum wiring follow the procedure below:

1. Connect a section of solid copper wire to the pigtail 

leads.

2. Connect the aluminum wiring to the added section of 

copper wire using special connectors and/or tools 
designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended 
procedure. Aluminum/copper connection must conform with 
local codes and industry accepted wiring practices.

You may need to shave or cut the trim of formed or metal front-
edged countertops to clear the 30" (76.2 cm) width of the 
cooktop.

Countertop must be notched as shown to avoid damaging the 
oven control panel.

Notch countertop as shown to clear oven control panels.

A

¹⁄₈" (76.5 cm) width

¹⁄₂" (3.8 cm) max.

¹⁄₈" (76.5 cm) width

¹⁄₈" (3.8 cm) max.

C

B

A

B

C

D

A