Whirlpool RBS277PV Manual Do Utilizador

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Phillips screwdriver

■

Measuring tape

■

Hand or electric drill (for wall cabinet installations)

■

1" (25 mm) drill bit (for wall cabinet installations)

■

Level

■

UL listed or CSA approved conduit connector

■

UL listed wire connectors

■

# 8–14 x 1" screws - single oven (2), double oven (4)

■

Bottom vent (supplied on some models)

■

Two # 8–18 x 

³⁄₈" screws - bottom vent

■

Side trim

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”
It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

IMPORTANT: Observe all governing codes and ordinances. 

■

Cabinet opening dimensions that are shown must be used. 
Given dimensions provide minimum clearance with oven.

■

Recessed installation area must provide complete enclosure 
around the recessed portion of the oven. 

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

■

Electrical supply junction box should be located 3" (7.6 cm) 
maximum below the support surface when the oven is 
installed in a wall cabinet. A 1" (2.5 cm) minimum diameter 
hole should have been drilled in the right rear or left rear 
corner of the support surface to pass the appliance cable 
through to the junction box.

NOTE: For undercounter installation, it is recommended that 
the junction box be located in the adjacent right or left 
cabinet. If you are installing the junction box on rear wall 
behind oven, the junction box must be recessed and located 
in the upper or lower right or left corner of the cabinet; 
otherwise, the oven will not fit into the cabinet opening.

■

Oven support surface must be solid, level and flush with 
bottom of cabinet cutout. Floor must be able to support a 
single oven weight of 154 lbs (70 kg) or a double oven weight 
of 287 lbs (130 kg).

IMPORTANT: To avoid damage to your cabinets, check with 
your builder or cabinet supplier to make sure that the 
materials used will not discolor, delaminate or sustain other 
damage. This oven has been designed in accordance with the 
requirements of UL and CSA International and complies with 
the maximum allowable wood cabinet temperatures of 194° 
(90°C)

Ovens approved for this type of installation have an approval label 
located on the top of the oven. Refer to undercounter installation 
instructions for cutout dimensions and approved oven cooktop 
combinations (separate sheet).

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety 
messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean: