Westinghouse EPA (49 state) WH6500E Manual Do Proprietário
25
OPERATION
Starting an Electric Start Generator
1. Verify the battery is properly installed and both
battery cables are attached (see Installing the
Battery (Electric Start Generators Only) on page
15).
2. Make sure the circuit breakers are properly set (see
Figure 21).
1
2
3
4
Figure 21 – Circuit Breakers
1 - 240/120V Main
Circuit Breaker
Operating
Position
2 - 240/120V Main
Circuit Breaker
Tripped Position
3 - 120V Circuit
Breaker
Operating
Position
4 - 120V Circuit
Breaker Tripped
Position
3. Move the fuel shutoff valve to the
ON position (see
Figure 22).
Figure 22 – Fuel Shutoff Valve in the
ON Position
4. Move the choke lever to the
ON position (see
Figure 23).
Figure 23 – Choke Lever
5. Push and hold the engine control switch in the
START position until the engine starts. Once the
engine starts, release the engine control switch; the
switch will automatically move into the
RUN position
(see Figure 24).
Figure 24 – Engine Control Switch
NOTICE
Failure to release the engine control switch once
the engine starts could result in damage to the
generator.
Never push the engine control switch to the
Never push the engine control switch to the
START
position while the engine is running; this could
damage the generator.
6. As the engine starts and stabilizes, gradually move
the choke lever back to the
OFF position.