Westinghouse EPA (49 state) WH6500E Manual Do Proprietário

 33

8.  Install the spark plug by carefully following the steps 

outlined below:
a -  Carefully insert the spark plug back into the 

cylinder head. Hand-thread the spark plug until 

it bottoms out.

b -  Using the 13/16" spark plug socket wrench 

provided, turn the spark plug to ensure it is fully 

seated.

c -   Replace the spark plug boot, making sure the 

boot fully engages the spark plug’s tip.

Recommended Spark Plug Replacement:

BATTERY SERVICE

To ensure the battery remains charged, the generator 

should be started every 2 to 3 months and run for a 

minimum of 15 minutes. If the generator is stored more 

than a year without running, a battery charger may be 

needed to recharge the battery. 

1.  Remove the spark plug wire from spark plug.

2.  Loosen and remove the nuts on the battery hold-

down plate and remove the plate from the support 

rods (see Figure 39).

1 -  Nuts
2 -   Battery  Hold- 

Down Plate

3 -  Support Rods 

3.  Tip the battery forward slightly to access battery 

cables.

4.  Disconnect the black negative (-) battery cable from 

the battery first.

5.  Disconnect the red positive (+) battery cable 

second and remove the battery.