Welch Allyn Medical Diagnostic Equipment Medical Alarms 8.1x Manual Do Utilizador
Directions for use
Chapter 4 Adjust monitoring settings and patient information
69
Examine the ST Analysis Setup window
The ST Analysis Setup windows in this section are shown in alarm.
To open an ST Analysis Setup window
•
In the patient’s Virtual Monitor, click Setup, ST Analysis.
The ST Analysis Setup window appears.
To examine the ST Analysis Setup window
The current beat is shown for one or two leads.
Deviation (mm or mV) of the current ST-segment offset from the
reference ST-segment offset, for each lead.
reference ST-segment offset, for each lead.
Red numbers indicate alarm values.
Analysis is performed on the selected leads.
Horizontal line marks the isoelectric reference baseline for the
ECG waveform.
ECG waveform.
The reference beat is learned when the Acuity System learning or
relearn function occurs.
relearn function occurs.
Undoes what has been done since the window was opened,
except ST RELEARN and measurement Lead choices.
except ST RELEARN and measurement Lead choices.
One or two active leads can be displayed.
Open Alarms, Printouts, Waveform Window, Arrhythmia Alarms
and ST Analysis Setup windows.
and ST Analysis Setup windows.
J. J-points
(green)
D. Isoelectric reference
baseline (green)
B. Deviation from
reference beat
A. Current beat (white)
F. Undo button
H. Setup window buttons
C. Measurement leads
G. Display leads
I. Measurement
offset
E. Reference beat (green)