Weider SLANT BOARD BENCH WECCBE1000 Manual Do Proprietário

2.

Press two 1 3/4” Cover Caps (10) onto the
Adjustment Foot (4). 

Press two 3/4” Inner Caps (12) into the Short Pad
Bar (7). Slide the Swing Arm (3) onto the
Adjustment Foot (4) and align the hole in the Swing
Arm with one of the holes in the Adjustment Foot.
Slide the Short Pad Bar into the holes in the Swing
Arm and the Adjustment Foot. 

Wet the ends of the Short Pad Bar (17) with soapy
water. Slide a Large Foam Pad (8) onto each end of
the Short Pad Bar.

• Place all parts in a cleared area and remove the

packing materials; do not dispose of the packing
materials until assembly is completed. 

• Read each assembly step before you begin.

• Tighten all parts as you assemble them, unless

instructed to do otherwise. 

• During assembly, make sure that all parts are ori-

ented as shown in the drawings. 

Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.

16

17

12

5

5

3

1

1.

Press a 1 1/2” Square Inner Cap (16) into the top of
the Swing Arm (3). 

Press two 3/4” Inner Caps (12) into the Long Pad
Bar (17). Slide the Long Pad Bar into the indicated
hole in the Swing Arm (3). 

Wet the ends of the Long Pad Bar (17) with soapy
water. Slide a Small Foam Pad (5) onto each end of
the Long Pad Bar.

8

12

7

8

3

4

2

10