Mazda Remote Starter C930 V7 620 Manual Do Utilizador

20 

 
This operation only applies when the engine has been started with the remote 

control. 

 
z

  Press the function switch once. 

The LCD display will appear as 

shown on the right. 

 

 

 

 
z

  Press the start switch while the 

above LCD display is shown until it 

beeps. 

After the send mark flashes, the 

send operation is completed. After 

the send operation is completed, 

the controller will send an answer 

back signal. 

*Press the start switch within 2 seconds after the LCD display appears. If the 

start switch is not pressed in time and the LCD display disappears, start the 

procedure over again from step 1. 

 

When the remote control receives a 

response from the vehicle, it indicates 

the engine start operation with the 

display below and a melody. 

・ 

Warm up time remaining? 

(It only displays even numbers.) 

・

 Is the engine running? 

・

 Is the rear defrost turned on? 

The LCD display will appear when the 
switch is released. 

 

Function switch 

While LCD 

dis
pla

ys

Start switch 

【

Display Example】 

・

8 min. warm up time remaining 

・

Engine running 

・

Rear defrost stopped