Rosewill RC-219 Manual Do Utilizador

RC-219                                    User Manual 

 

 

 

3  

1.

  Power off the system. Insert SATA Card into an available PCI slot. Connect serial 

ATA cable(s) between the SATA port and serial ATA device(s). Power up the 

system. 

2.

  Put your Windows NT/2000/XP or Windows Server 2003 CD into the 

CD-ROM/DVD drive, or the NT/2000 boot diskette #1 in the floppy drive if your 

system cannot boot from the CD. 

3.

  Press F6 for third party SCSI or driver installation at the beginning of text mode 

installation. Press 'S' when setup asks if you want to specify an additional 

device, and insert the driver CD. Press 'Enter' and select 'Silicon Image SiI 

3132 SATALink Controller'. 

4.

  Press 'Enter' again when prompted to continue on with text mode setup. 

5.

  Follow the setup instructions to select your choice for partition and file system. 

6.

  After setup examines your disks, it will copy files from the CD to the hard drive 

selected above and restart the system. After restart the setup process will resume 

to finish the installation. 

7.

  Once the operating system installation has completed you can follow the 

instructions in section 2.4 to verify controller was installed correctly. 

 

1.

  Power off the system. Insert SATA Card into an available PCI slot. Connect serial 

ATA cable(s) between the SATA port and serial ATA device(s). Power up the 

system. 

2.

  After OS boots up, Click 'Start' 

3.

  Under 'Settings', click 'Control Panel'. 

4.

  Select 'SCSI Adapters' from the Control Panel. 

5.

  Select the 'Drivers' tab and click 'Add'. 

6.

  Click 'Have Disk'. 

7.

  Points specify a location, example E:\SATA Express_2Port \Sil3132 \ 

WinXP_2000_2003_NT, and click “OPEN” then “OK” 

8.

  Choose 'Silicon Image SiI 3132 SATALink Controller' and click 'OK'.