Sony Microscope & Magnifier snt-v Manual Do Utilizador
preliminary
33
HSR View Mode
Images from the HSR-1/1P/2/2P are displayed in the
HSR View. Screen buttons and icons allow switching
cameras, controlling pan/tilt/zoom, changing display
modes and controlling the HSR-1/1P/2/2P.
HSR View. Screen buttons and icons allow switching
cameras, controlling pan/tilt/zoom, changing display
modes and controlling the HSR-1/1P/2/2P.
Note
When multiple users are logged on at the same time,
operations of other users may cause the HSR View to
change unexpectedly. Check the Users Logged On
field to determine if other users are logged on.
operations of other users may cause the HSR View to
change unexpectedly. Check the Users Logged On
field to determine if other users are logged on.
1
Indicators
A blue indicator appears above a camera number
button to indicate that pan/tilt/zoom control is
available via a connected EVI-D30/D31/G20/G21. If
no video camera ID number has been set in the system
settings, or if an EVI-D30/D31/G20/G21 is not
connected or is turned off, this indicator is colored
gray.
button to indicate that pan/tilt/zoom control is
available via a connected EVI-D30/D31/G20/G21. If
no video camera ID number has been set in the system
settings, or if an EVI-D30/D31/G20/G21 is not
connected or is turned off, this indicator is colored
gray.
6
4
5
7
8
9
0
0
qa
qd
3
2
Camera Number Buttons
Clicking one of these buttons displays the image from
that video camera.
While monitoring an image, the camera number on the
button corresponds to the video input terminal on the
HSR-1/1P/2/2P. No camera number appears on a
button if the corresponding input terminal has been set
to [DISCONNECT] for the camera connection. When
playing a tape, the camera number buttons are
displayed for those cameras that were on when the tape
was recorded. In this case, no camera number appears
on a button if that camera was set for [NO
RECORDING] at the time the recording was made.
that video camera.
While monitoring an image, the camera number on the
button corresponds to the video input terminal on the
HSR-1/1P/2/2P. No camera number appears on a
button if the corresponding input terminal has been set
to [DISCONNECT] for the camera connection. When
playing a tape, the camera number buttons are
displayed for those cameras that were on when the tape
was recorded. In this case, no camera number appears
on a button if that camera was set for [NO
RECORDING] at the time the recording was made.
qs
qk qj
qh qg qf
2
1