Sierra Wireless RAVEN 1X 20070914 Manual Do Utilizador
Global Positioning System (GPS)
Rev 3.0B Feb.08
98
NMEA Configuration
Messages Over-The-Air (Remote)
To configure the PinPoint X to send NMEA reports to a remote
server, you will need to set 3 commands: *PPIP, *PPPORT, and
*PPGPSR.
server, you will need to set 3 commands: *PPIP, *PPPORT, and
*PPGPSR.
a.
Set *PPIP and *PPPORT to the IP address and port of
the server to which you want the reports sent.
the server to which you want the reports sent.
Figure 10-24: AceManager : PinPoint - *PPIP/*PPPORT
b.
Set the GPS Report Type (*PPGPSR) to your preferred
NMEA sentence format.
NMEA sentence format.
Figure 10-25: AceManager : PinPoint - *PPGPRSR
•
E0 ‐ NMEA GGA and VTG sentences.
•
E1 ‐ NMEA GGA, RMC, and VTG sentences.
Local Host
Local reports are sent to the local IP address of the computer or
device connected to the serial port or USB port of the PinPoint
X using PPP. To configure the modem to send to the local IP,
you will need to set 3 commands: *S53, *PPLATS, and
*PPLATSR.
device connected to the serial port or USB port of the PinPoint
X using PPP. To configure the modem to send to the local IP,
you will need to set 3 commands: *S53, *PPLATS, and
*PPLATSR.
a.
Set the port (S53) to the local port to which you want
the reports sent. The local IP address will automati‐
cally be used. S53, in AceManager, is part of the Misc
group.
the reports sent. The local IP address will automati‐
cally be used. S53, in AceManager, is part of the Misc
group.