Polk Audio MagniFi Manual Do Proprietário
2
Safety Precautions
FCC Statement
1. This device complies with Part 15 of the
1. This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
undesired operation.
CAUTION: Any changes or modifications not expressly
approved by the grantee of this device
could void the user’s authority to operate
the equipment.
could void the user’s authority to operate
the equipment.
Federal Communitcations Commission
Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment
Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment
and receiver.
(3) Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
connected.
(4) Consult the dealer or an experienced radio/TV
technician for help.
RF Exposure Warning
This equipment must be installed and operated
in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all
persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and
installers must be provide with antenna installation
instructions and transmitter operating conditions for
satisfying RF exposure compliance.
5GHz RF Device Statement
5.15~5.25MHz Band
This equipment must be installed and operated
in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all
persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and
installers must be provide with antenna installation
instructions and transmitter operating conditions for
satisfying RF exposure compliance.
5GHz RF Device Statement
5.15~5.25MHz Band
• This device is operation in 5.15 – 5.25GHz frequency
range, then restricted in indoor use only,
• Outdoor operations in the 5150~5250MHz is
prohibit.
prohibit.
Master Equipment:
The availability of some specific channels and/or
operational frequency bands are country dependent
and are firmware programmed at factory to match
the intended destination. The firmware setting is not
accessible by the end user.
This device is Master equipment, the transmission is
disabled in the 5600-5650MHz band.
Slave Equipment:
This device is slave equipment, the device is not radar
detection and not ad-hoc operation in the DFS band.
FCC RF Warning
This equipment must be installed and operated
in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all
persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and
installers must be provide with antenna installation
The availability of some specific channels and/or
operational frequency bands are country dependent
and are firmware programmed at factory to match
the intended destination. The firmware setting is not
accessible by the end user.
This device is Master equipment, the transmission is
disabled in the 5600-5650MHz band.
Slave Equipment:
This device is slave equipment, the device is not radar
detection and not ad-hoc operation in the DFS band.
FCC RF Warning
This equipment must be installed and operated
in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all
persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and
installers must be provide with antenna installation