Pelco Environmental Power Supply C561M-F Manual Do Utilizador

C561M-F (8/06)

Installation

MOUNTING INSTRUCTIONS

To mount the power supply directly to a wallboard, wall, or concrete refer to Figure 1 through 3 and
do the following:

1. Remove the retaining screw from the door latch of the WCS1-4 power supply.

2. Open the door of the WCS1-4 power supply, and then remove the plug(s) from the required

conduit hole(s) located on the bottom of the unit. Install 3/4-inch (1.91 cm) conduit fitting(s)
(not supplied). Close the lid to the power supply.

3. Determine the mounting location for the WCS1-4.

4. Use the WCS1-4 power supply as a template and mark the four fastener positions on the

mounting surface.

5. Prepare the holes for installation.

6. Attach the WCS1-4 power supply securely to the mounting surface with four fasteners of

appropriate length. Fasteners between 1/4-inch and 5/16-inch diameter (not supplied) can be
used.

Figure 1.

Mounting to Wallboard

Figure 2.

Mounting to Wall

Figure 3.

Mounting to Concrete

WARNING: Under light load conditions and high input power voltage, output voltage from the
WCS1-4 power supply may reach 32 VAC. Pelco recommends that all equipment
connected to the WCS1-4 power supply be rated to handle 32 VAC. Pelco’s Spectra

domes

and Esprit

integrated positioning systems meet this requirement. Pelco cannot be liable for

any damages resulting from incorrect wiring of the WCS1-4 power supply.

CONDUIT
FITTINGS

Mounting to Wallboard

Mounting to Wall

MOUNTING HARDWARE WITH
ANCHOR OR TOGGLE BOLT
(NOT SUPPLIED)

Mounting to Concrete

WOOD SCREW
(NOT SUPPLIED)

MOUNTING
HARDWARE
(NOT SUPPLIED)

CONCRETE WALL

WALL

WALLBOARD

DOOR

LATCH

RETAINING

SCREW

DOOR

LATCH

RETAINING

SCREW

DOOR

LATCH

RETAINING

SCREW