KitSound Ovation Manual Do Utilizador
9
Positioning
For best results, the Ovation should be at ear level of normal listening, with the front facing the listening area and 10 cm away from the wall.
Depending on your set up, you can either put the Ovation on your TV stand or mount it onto the wall.
Depending on your set up, you can either put the Ovation on your TV stand or mount it onto the wall.
Wall mounting
To avoid the risk of personal injury and damage to the unit, installation should be done only by qualified or competent persons.
Note: For best results, the speaker should be installed at least 10 cm (4 inches) below your television.
Please note that due to the weight of the ovation, we only recommend wall mounting onto solid brick/concrete walls and stud walls only
if you are able to locate and fix each of the 3 anchor points into the actual studs.
1. Put the 2 short supplied hand screws into the holes at the rear of the unit (do not tighten fully)
2. Connect the bracket to the Ovation, making sure that the large hole is at the top
3. Tighten the screws
4. Offer the Ovation and bracket up to the wall and once you’re happy that it is level and central, mark the 3 holes
5. Drill your marks using a 6.5-8 mm drill bit (depending on how soft/hard your walls are)
6. Insert the grey wall plugs into the holes
7. Use the 3 long screws to fix the bracket tightly to the wall
8. Loosen the hand screws attaching the bracket to the Ovation by ¾ of a turn and slide the bracket off
9. Ensure that all cables are connected to the Ovation
10. Attach the Ovation to the bracket by sliding onto the bracket (if too stiff, loosen the hand screws, if too loose, tighten them)
11. Finally, tighten the hand screws until the Ovation is securely clamped against the bracket
Note: For best results, the speaker should be installed at least 10 cm (4 inches) below your television.
Please note that due to the weight of the ovation, we only recommend wall mounting onto solid brick/concrete walls and stud walls only
if you are able to locate and fix each of the 3 anchor points into the actual studs.
1. Put the 2 short supplied hand screws into the holes at the rear of the unit (do not tighten fully)
2. Connect the bracket to the Ovation, making sure that the large hole is at the top
3. Tighten the screws
4. Offer the Ovation and bracket up to the wall and once you’re happy that it is level and central, mark the 3 holes
5. Drill your marks using a 6.5-8 mm drill bit (depending on how soft/hard your walls are)
6. Insert the grey wall plugs into the holes
7. Use the 3 long screws to fix the bracket tightly to the wall
8. Loosen the hand screws attaching the bracket to the Ovation by ¾ of a turn and slide the bracket off
9. Ensure that all cables are connected to the Ovation
10. Attach the Ovation to the bracket by sliding onto the bracket (if too stiff, loosen the hand screws, if too loose, tighten them)
11. Finally, tighten the hand screws until the Ovation is securely clamped against the bracket