Maretron TLM100 Manual Do Utilizador

 

 

1” (2.54cm) clearance 
between focus tube and 
tank bottom 

TLM100 Interface Component 

Threaded Tank Fitting 

Threaded Focus Tube 

TLM100 Gasket 

TLM100 Sensor Component 

Mounting Screws 

 

 
2.4.1.6  Installation on a Tank with a 1.25”BSP or 1.5”NPT Threaded Tank Fitting and 

 
Installation of the TLM100 on a tank with a 1.25” BSP or 1.5” NPT threaded tank fitting with an 
airlock is identical to installation with a focus tube, except that the trimming step is eliminated. 
Please refer to Section 2.4.1.5 for details of the mounting procedure. 
 

The actual mounting of the TLM100 interface component is not critical and the unit can be 
mounted in any orientation. The TLM100, NMEA 2000

®

 connector, and cable are all 

waterproof (rated IP67 – protected against temporary immersion in water) so you can mount 
the unit virtually anywhere. Once you have located a suitable mounting location, you can 
secure the TLM100 interface component by placing wire ties with screw eyes on the attached 
cables next to the TLM100 interface component. Do not use threadlocking compounds 
containing methacrylate ester, such as Loctite Red (271), as they will cause stress cracking of 
the plastic enclosure.