Logic Controls LC8000 Manual Do Utilizador

9 

LC8000 User Manual Rev. 1 

 

 
If you encounter a hardware problem, we recommend that you review the following suggestions 
before calling for service: 
 
General failure 

•  Are all cables securely plugged? 

•  Are all system components and peripherals turned on? 

•  Is the system main power switch on? 

•  Is the power outlet burned out? You may check this by plugging in and turning on 

another piece of equipment. 

•  Are any cables damaged? Are they properly routed and coiled? Entwined cables may 

cause signal interference. 

•  Reset the unit 

ƒ

  Perform a power reset (unplug the adaptor the from power socket for 5 minutes and 

then plug the adaptor in again). 

•  Is the keyboard cable plugged in? Turn off the system and plug in the keyboard. 

 
Caution: Do not plug or unplug the keyboard while the power is on. 

 
Depending on the configuration of your LC8000 whether it is equipped with either an internal 
hard-drive or compact flash card or both, the BIOS will be pre-programmed to boot from that 
particular device. If you need to boot from an external device or if you have upgraded your 
compact flash card or hard-drive you will need to change settings in the BIOS. The following 
steps show how to change the boot sequence within the BIOS. 
 

1.  Turn on or reboot your system. After a series of diagnostic checks, the following 

message will appear:  

   PRESS <Del> TO RUN SETUP 
 
2.  Press the <Del> key and the BIOS setup main screen will appear as follows. 

 

►Standard CMOS Features 
►Advanced BIOS Features 
►Advanced Chipset Features 
►Power Management Features 
►PNP/PCI Configurations 
►Integrated Peripherals 
►PC Health Status 
►Frequency/Voltage Control 
 

►System Information 
Set Supervisor Password 
Load Optimal Defaults 
Load Fail Safe Defaults 
Save & Exit Setup 
Exit Without Saving 

F1: Help        ↑↓: Select Item 

+/-: Change Values 

F9: Setup Defaults 

Esc: Exit        ←→: Select Menu 

Enter: Select ►Sub-Menu 

F10: Save & Exit