Honeywell RM7824A Manual Do Utilizador

7800 SERIES RM7824A RELAY MODULE

65-0155—1

9

NOTE:

For installation dimensions, see Fig. 1 or 2.

1. Mount the RM7824A vertically, see Figs. 7 or 8, or

mount horizontally with the knife blade terminals
pointing downward. When mounted on the Q7800A, the
RM7824A must be in an electrical enclosure.

2. Select the location in the electrical enclosure. Be sure to

allow adequate clearance for servicing, installation and
removal of the RM7824A, dust cover, flame amplifier,
flame amplifier signal voltage probes, electrical signal
voltage probes and electrical connections.

a.

Allow an additional two inches below the
RM7824A for the flame amplifier mounting.

b.

Allow an optional three-inch minimum to both
sides of the RM7824A for electrical signal voltage
probes.

3. Make sure no subbase wiring is projecting beyond the

terminal blocks. Tuck in wiring against the back of the
subbase so it does not interfere with the knife blade
terminals or bifurcated contacts.

The RM7824A must be installed with a plug-in
motion rather than a hinge action.

4. Mount the RM7824A by aligning the four L-shaped

corner guides and knife blade terminals with the
bifurcated contacts on the wiring subbase and securely
tightening the two screws. Do not tighten the screws to
the point where they deform the plastic of the RM7824A
case.

1. Align the two interlocking ears of the Dust Cover with

the two mating slots on the RM7824A (see Fig. 9).

2. Insert the two interlocking ears into the two mating

slots, and with a hinge action, push on the upper
corners of the Dust Cover to secure it to the RM7824A.

3. Be sure the Dust Cover is firmly in place.

1. Disconnect the power supply before beginning

installation to prevent electrical shock and equipment
damage. More than one disconnect may be involved.

2. Align the amplifier circuit board edge connector with the

keyed receptacle on the RM7824A. Verify that the
amplifier nameplate faces away from the Relay Module
(see Fig. 10).

3. Push in the amplifier until the circuit board is fully

inserted into the receptacle and then push the amplifier
toward the RM7824A retaining clasp.

4. Verify the amplifier is firmly in place.
5. Perform all required checkout tests.