Flying Mole DADM310 Folheto

Before proceeding with the setup, make sure that the following accessory is included in the package.

If it is missing, please contact the dealer whom you purchased the amplifier from, or Flying Mole Corp.

(this booklet) x 1

● Equipped with high-speed, floating, full-resonance

● Flying Mole Bi-Phase PWM amplifier technology realizes

● Equipped with real-time current limiter

● Gorgeous parts for uncompromising standards

● General-purpose input interface allows connection with

■ Front Panel

■ Rear Panel

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICE

ABLE PARTS INSIDE. REFER SERVICING TO  QUALI-FIED SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGEROUS

VOLTAGE CONSTITUTING A RISK OF ELECTRIC

SHOCK IS PRESENT WITHIN THIS UNIT.

THIS SYMBOL INDICATES THAT THERE ARE IMPOR-

TANT OPERATING AND MAINTENANCE INSTRUC-

TIONS IN THE OWNER’S MANUAL WITH THIS UNIT.

WARNING : 

To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampli-

fiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one

wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third

prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the

point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the

apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in

any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operated normally, or has been dropped.

■ The important safety instructions

THE APPARATUS IS NOT WATERPROOF. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE AND DO NOT PUT ANY WATER SOURCE NEAR THIS APPARATUS, SUCH

AS VASE, FLOWER POT, COSMETICS CONTAINER AND MEDICINE BOTTLE, ETC.

If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and  “ON”,
please try to eliminate the problem by using one of the following measures :
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna.
If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute
this type of product. If you can not locate the appropriate retailer, please contact Flying Mole Corporation.

q Power Switch / Power Indicator

Used to turn the amplifier’s power ON or OFF.

The ON indicator (blue) lights when the power is

turned on.

When the power amplifier is on standby in REMOTE

ON MODE (refer to 

i), the SLEEP indicator (orange)

is on.

w LEVEL Adjustment Knobs

Used to control the output level.

Setting the knob to “0” turns down the level to the

minimum.

q

w

e

y

t

i

r

u

eINPUTS / INPUT Selector

Used to connect the input signal to the amplifier.

Connect an input to a preamplifier, etc.

Select one of the following settings depending on

which input is connected.

● INPUT: UNBAL - FIXED

The LEVEL adjustment knob 

w on the front panel is

bypassed.

● INPUT: UNBAL - VARIABLE

The level can be adjusted with the LEVEL adjust-

ment knob 

w on the front panel.

(Switch position: left)

(Switch position: center)

● INPUT: BAL - VARIABLE

The level can be adjusted with the LEVEL adjust-

ment knob 

w on the front panel.

(Switch position: right)

rSPEAKER Outputs

Used to connect the output signal from the amplifier.

Connect to the speaker with SP cables.

tOUTPUT Connector 

When balanced signals are input, the same signals

as the input signals are output. The signal arrange-

ment of the BALANCE OUTPUT on this product is:

yAC IN CONNECTOR

Used to connect the supplied AC power cable to the

amplifier.

Connect the other end of the AC power cable to

household AC outlet.

uREMOTE POWER CONTROL Connectors

● OUT

Used to interlock the power on the device con-

nected to this product with the activation/deacti-

vation of power on this product.

Connect these outputs to a Flying Mole product

equipped with remote power control trigger inputs.

● IN

Used to interlock the power on this product with

the activation/deactivation of power on another de-

vice.

Connect these inputs to a Flying Mole product

equipped with remote power control trigger out-

puts.

iMODE Selector

Used to switch if the power is controlled by the

POWER switch or by REMOTE POWER CONTROL

trigger signals.

● MANUAL ON MODE

The power is turned ON or OFF with the POWER

switch 

q on this product.

● REMOTE ON MODE

The power is interlocked with the activation/deac-

tivation of power on the device connected to the

REMOTE POWER CONTROL (IN) of this prod-

uct.

q of this product to ON posi-

q is turned OFF.

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○