Argox OS-214 plus Manual Do Utilizador

 

 

54

LED Indicators: Power and Ready LEDs blink alternately 

 

Power LED  Ready LED 
ON OFF 
OFF ON 
 

Ribbon out 

Supply the ribbon roll 

Ribbon jam 

Recover the jam 

Ribbon sensor error Replace ribbon sensor 

Not applicable to 
direct thermal 
type. 

 
 
LED Indicators: Only the Power LED blinks 

 

Power LED  Ready LED 
ON ON 
OFF ON 
 

Serial IO error 

Check the baud rate 

Not for Centronics 

Memory full 

Add the extension RAM  

Cutter failed, or jam 
at cutter 

Check the cutter 
Recover the jam 

Occurs only when 
installing or setting the 
cutter 

Hardware error 

Call for service 

 

 
 

 

 

55

 
If the host shows "Printer Time out" 

1.  Check if the communication cable (parallel or serial) is 

connected securely to your parallel or serial port on the 
PC and to the connector on the printer at the other end. 

2.  Check if the printer power is turned on. 

 
If the power cord is connected, the power switch is at position "I" 
and the power LED is still not illuminated, check the fuse inside 
the power adapter case. 
 
If the data has been sent, but there is no output from the printer. 
Check the active printer driver, and see if Label Dr. for your 
Windows system and the label printer has been selected. 
 
Vertical streaks in the printout usually indicate a dirty or faulty 
print head. (Refer to the following examples.)