Argox OS-214 plus Manual Do Utilizador

 

 

72

13. Unlatch the print head module. Hook the white roller on 

the brackets of the chassis, ensuring the long thinner end 
is on the left side. 

14. Guide the shaft through the respective holes on the left 

bracket, the white roller and then the right bracket in order. 
(To smooth this procedure, hold the white roller with one 
hand.) 

15. Secure the attached screw to the right bracket of the 

chassis to fix the shaft. 

16. Hook the dispenser bar on the brackets of the chassis, 

positioning it above the white roller. Ensure that the 
dispenser bar is parallel with the black platen roller and its 
long thinner end is on the left.   

17. Secure the screw on the left bracket of the chassis. 
18. Guide the sensor cable connector through the hole on the 

upper left corner of the middle cover. 

 
 
 
 
 
 
 
 
       
 
 
 
 
 

Screw

Shaft 

White Plastic Roller 

Dispenser Bar

 

 

73

19. Click the top cover back onto the middle cover. 
20. Insert the sensor connector into its receptacle on the main 

logic board of the base housing. 

21. Click the middle cover back into the base housing. First 

click in the front then the rear. 

22. Secure the two screws at the bottom of the base housing. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

H. Cover 

Middle Cover 

4 mm Gap