BMW 2006 M6 Coupe Manual Do Proprietário

188

To avoid serious or fatal injury: never lie under 
the vehicle, and never start the engine while it is 
supported by the jack.

<

To avoid rattling noises later on, note the posi-
tions of the tools before removing them, then 
return them to their initial positions after com-
pleting work.

1 Chock

2 Vehicle jack

3 Lug wrench

The tools are located in the hollow of the spare 
wheel

.

1.

Pull back lock

1, fold open clamp lock 2 

completely and loosen the belt

3.

2.

Remove the cover

4.

3.

Take the tool mount out of the spare wheel.

4.

Remove the spare wheel.

1.

Observe the safety precautions above.

2.

Prevent the vehicle from rolling:
Place the chock behind the front wheel on 
the other side of the vehicle, or on inclines, 
in front of this wheel. On a steep grade, take 
other steps to prevent the vehicle from roll-
ing.

3.

Loosen the lug bolts a half turn.

The jacking points for the car jack are located in 
the positions shown.

1.

Position the vehicle jack at the jacking point 
closest to the wheel so that the entire sur-
face of the jack base rests on the ground 
perpendicularly beneath the jacking point.

The vehicle jack is designed for 
changing wheels only. Do not attempt 

to raise another vehicle model with it or to 
raise any load of any kind. To do so could 
cause accidents and personal injury.

<

2.

Guide the jack head into the rectangular 
recess of the jacking point when cranking 
up, refer to illustration detail.

3.

Jack the vehicle up until the wheel you are 
changing is raised from the ground.

Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG