Wyse R10L Manual Do Utilizador
Installing Xenith Pro Firmware
7
Figure 7 Prepare USB key for configuration
10.Select the USB key onto which you want the configurations (you can use Refresh as
needed to recognize an inserted USB key), and then click Next. The progress bars
show the overall (formatting and configuration) progress and task progress.
CAUTION: DO NOT interrupt the formatting and configuration process. All process
requirements are done automatically. The progress screen may display for several
seconds or longer. You can safely ignore any error message.
show the overall (formatting and configuration) progress and task progress.
CAUTION: DO NOT interrupt the formatting and configuration process. All process
requirements are done automatically. The progress screen may display for several
seconds or longer. You can safely ignore any error message.
11.After configuration, click Finish to close the wizard and then remove the configured
USB key for use (you will use the configured USB key on your target devices).
TIP: At this time you can also replicate/duplicate the configured USB key (containing the
firmware you want to push) for simultaneous usage on target devices (by users in several
locations at the same time). For full Wyse USB Firmware Tool details, see Users Guide:
Wyse
firmware you want to push) for simultaneous usage on target devices (by users in several
locations at the same time). For full Wyse USB Firmware Tool details, see Users Guide:
Wyse
®
USB Firmware Tool 1.18.
Step 4: Use the Configured USB Key to Install Firmware on Each Thin Client
In this step, you will boot each thin client you want to convert from the configured USB key
so that the USB key will push the contents from the USB key onto the target device.
so that the USB key will push the contents from the USB key onto the target device.
1. Be sure the client is shut down and disconnected from any network.
2. Attach the configured USB key to the client.
3. Power on the client and during boot, press and hold the P key.
4. Select the USB HDD drive option from the menu (this option also displays the brand of
your configured USB key).
5. Press Enter and follow the process prompts. When booting a target device from the
configured USB key (containing the contents to be pushed to a target device), you will
be prompted to continue with the push process (to continue, type y and press Enter).
Once the push process is complete, you must reboot (press Enter and remove the
USB key).
CAUTION: DO NOT interrupt the installation/conversion process. All process
requirements are done automatically. Some screens may display for several seconds
during the process.
be prompted to continue with the push process (to continue, type y and press Enter).
Once the push process is complete, you must reboot (press Enter and remove the
USB key).
CAUTION: DO NOT interrupt the installation/conversion process. All process
requirements are done automatically. Some screens may display for several seconds
during the process.
6. After a target device completes the installation/conversion process and displays the
Xenith Pro desktop, continue with
.