Spracht CP-2012 Manual Do Utilizador

• Install the two mounting screws supplied with the Analog Interface in the

wall. Leave approximately 3/16 in. (0.5 cm) between screw head and wall.

• Place the Analog Interface over the mounting screws and slide it down 

to fix it in position.

The user may select either pulse or tone dialing (DTMF, dual-tone multi-frequency).
To change the dialing mode:

• Slide the switch located on the side of the Conference Phone to match the

dialing mode of the telephone network being used. Factory setting is Tone.

To conduct private conversations using a handset, you may connect a 
standard analog telephone to the Voice Center Analog Interface:

• Plug a standard RJ-11 cable from the analog telephone into the 

connector in the Analog Interface labeled ”Phone”.

The standard phone is then connected to the telephone line in parallel with the Conference Phone, and
the standard phone and Conference Phone can be used independently.

To transfer a call from the Conference Phone to an external analog telephone connected as noted above:

• Pick up the analog telephone handset while the Conference Phone is on.

• Turn off the Conference Phone by pressing its ON/OFF key.

To transfer a call from the external analog telephone to the Conference Phone:

• While the private call is in progress, turn on the Conference Phone by pressing its ON/OFF key.

• Hang up the handset of the external telephone.