Ronco Popeil Pasta / Sausage Maker Manual Do Utilizador

 
 

•  Make sure dry and liquid ingredients are completely mixed before switching 

Popeil’s Pasta/ Sausage Maker to EXT (extrude). Never try to extrude pasta 
dough which is too dry and floury. 

•  Always add dry ingredients (flour and seasonings) to mixing bin first; then close 

lid before slowly adding liquid. 

•  With some pasta dough, such as chocolate, the round bearing directly behind the 

kneading screw may squeak. If this happens, you can oil the bearing by coating it 
with vegetable oil. 

•  Do not put knife or anything through any opening on lid. They are for adding 

liquid, flour, or seasonings only. 

•  After MIX, always switch to OFF and let the motor completely stop before 

switching to EXT (extrude). 

•  The motor can produce a flash of light when being switched from MIX to EXT 

(extrude) or vice versa. This is normal. 

•  Do not block the vent holes in front of the pasta/ sausage maker. Avoid getting 

flour or anything in the front vents holes. If flour should get in the vent holes: 
unplug the machine and tip the Pasta/ Sausage Maker all the way forward until the 
vent holes are pointing straight down, and gently shake the Pasta/ Sausage Maker 
up and down over a trash can to remove any flour. 

•  Use a dampened cloth with a very mild detergent to wash the motor housing of 

your Pasta/ Sausage Maker; do not submerge base in water. 

•  Keep your Pasta/ Sausage Maker away from heat sources such as hot stove 

burners and oven tops when the oven is on. 

•  Make sure your Pasta/ Sausage Maker is properly and completely assembled 

before turning it on. 

•  If it is difficult to remove the front Locking Ring that holds the pasta die or 

sausage horn, switch the Pasta/Sausage Maker to MIX for a few seconds. Then 
turn the machine OFF and use the wrench provided to loosen the Locking Ring. 

•  Noise = Power. This is very powerful machine. Keep all hair, jewelry, clothing, 

spatulas and foreign articles away from it while in use. 

•  When turning the machine “OFF”, be sure to wait until the blades have 

completely stopped before opening the lid.