Universal Microelectronic T8511G Manual Do Utilizador

69-0961—4

2

MICROELECTRONIC HEAT PUMP THERMOSTAT

5 FEET

[1.5 METERS]

YES

NO

NO

NO

M10106

2. Use a pencil to mark the mounting holes. See

Fig. 2.

3. Remove the wallplate from the wall and drill two

3/16 inch holes in the wall (if drywall) as marked. For
firmer material such as plaster or wood, drill two
7/32 inch holes. Gently tap anchors (provided) into
the drilled holes until flush with the wall.

WIRES 
THROUGH WALL

WALL

MOUNTING 
HOLES

MOUNTING 
SCREWS

M6530

WALL
ANCHORS
(2)

4. Position the wallplate over the holes, pulling wires

through the wiring opening.

5. Loosely insert the mounting screws into the holes.
6. Tighten mounting screws.

All wiring must comply with local electrical codes and
ordinances. Refer to Fig. 3 through 5 for typical hookups.
A letter code is located near each terminal for
identification.

Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.

1. Loosen the terminal screws on the wallplate and

connect the system wires. See Fig. 6.

Use 18 gauge, color-coded thermostat cable for
proper wiring.

2. Securely tighten each terminal screw.
3. Push excess wire back into the hole.
4. Plug the hole with nonflammable insulation to

prevent drafts from affecting the thermostat.