Sea Frost Bait Freezer Manual Do Utilizador

 

1 

372 ROUTE 4 BARRINGTON, NH  03825 USA 

TEL (603) 868-5720   

FAX (603) 868-1040  

1-800-435-6708  

E-Mail:sales@seafrost.com 

 

        www.seafrost.com 

 

 

 

 
 

BF1 ~ BF2 ~ BF3  220-VOLT  

 
 
 
DESCRIPTION 
 
The Sea Frost Freezer system consists of several parts:  The cold plates or wrapped 
box liner (hidden cooling coils), a refrigerant control valve, copper connecting lines, a 
receiver filter drier with sight glass, a compressor / condensing unit and a thermostat. 
 
OPERATION 
 
With the thermostat in the “on” position, the compressor, fan, and pump (if equipped) 
will operate.  Ten minutes after starting the compressor the area near the valve or the 
top of a hidden coil box will begin to cool and frost.   
 
If you do not observe cooling, with the compressor and fan running, switch off 
the unit to avoid damage. 
 
Within a few minutes of starting the Bait Freezer, the tubing in close proximity to the 
valve and the valve itself will be noticeably cold.  (If after 20 minutes of operation the 
cooling in this area is not observed, do not continue to operate the system.) 
 
After several hours, the box temperature will cool to well below freezing.   
The first plate or the top section of a wrapped box will cool first.  Because it freezes first, 
all the moisture suspended in the air within the box condenses and freezes at this plate.  
Frost is not a good indication of proper operation; check the temperature with a 
thermometer.  When the box and contents cool to the desired setting, the compressor 
and fan will cycle on and off periodically to maintain the set temperature.