Tektronix Camcorder 2200 Manual Do Utilizador

3-103

Aux Menu

EFX LOOP MODE

— Turns the effects send loop on

EXT LOOP

off

NO LOOP

The

E-MEM CONTROL

column activates E-MEM recalls for the

BUS SELECT

choice. You must assign the Aux Bus to MISC, or a

DPM level, on the Config/Extern IF/DPM Setup/Map Aux Buses
Menu.

PVW and MASK recall control may be disabled, but they are
always assigned to the MISC E-MEM level.

NOTE:

Buses assigned to Kaleidoscope or Krystal are under their

control and are not effected by the switcher’s E-MEM system. Therefore,
E-MEM recall control is not possible with those buses.

If the Aux Bus Menu is delegated to Kaleidoscope, the Near Side,
Far Side, and Both Side selections are enabled.

NEAR SIDE

— the

NEAR SIDE

column indicates which side you

will be changing the input to.

FAR SIDE

— the

FAR SIDE

will be changing to the opposite side

or the side you don’t see. If FRONT is visible (displayed in the

NEAR SIDE

column), then BACK is the FAR side.

BOTH SIDES

— Use

BOTH SIDES

if you want to use the same

video image on both Near and Far sides (default selection).

TAKE

— Source changes may be made with the Aux button row

on the Control Panel, a Remote Aux Panel, or the

TAKE

button on

the Aux Bus Menu. The selection that will be acted upon next is
shown by a highlighted menu button, and in the APPLY
CHANGES TO column on the Aux Bus Menu.