Tektronix Camcorder 2200 Manual Do Utilizador
2-40
Section 2— Control Panel Descriptions
This condition occurs if (with
AUTO ReCalL
off) you enabled one
level, recalled a register, turned off that enable, turned on another
enable, recalled another register and re-enabled the first level. The
locations of the contributing registers can be determined by
turning on one enable at a time.
enable, recalled another register and re-enabled the first level. The
locations of the contributing registers can be determined by
turning on one enable at a time.
↑
/BANK
is a two-function key that can be used for bank selection
or for accessing “second” functions, that is,
LOCK
and
UNDO
.
Pressing the
↑
/BANK
button delegates the numeric keypad to
single-digit bank selection, and delegates buttons with second
functions to the second function.
functions to the second function.
The button lights when pressed, and stays lit until the delegation
is completed. Pressing
is completed. Pressing
↑
/BANK
a second time also terminates the
delegation.
Refer to the “E-MEM Registers” description for use of the
BANK
button, and to the
LOCK
and
UNDO
headings for use of the
↑
(second) function button.
LeaRN
is used for storing or “learning” the current panel setup in
a register or for learning a register sequence.
NOTE:
Only areas which are enabled will be learned. For more
.
LeaRN
,
BANK
,
bank number
,
register number
If the next desired register is in the current bank, you may press
just the desired
just the desired
register number.
If the desired bank is 0 or 1, you may substitute
BANK 0
or
BANK
1
for
BANK
,
bank number
in the above sequences.
Refer to the
SEQ
button description for learning a register
sequence.
Bank
Lock
Learn