Techko S201 Folheto

Página de 2
 * Solar powered
 * High power output alarm
 * 2 sensors to correctly detect a real motion threat
 * Remote control for arming and disarming  
 * Red flashing LED light indicates intrusion
 * Easy to install
 * Low battery LED indicator
 * Alarm/Chime Option
 
 1. Read all installation and operating instructions.
 2. Avoid dropping or rough handling. 
 3. Be careful not to damage the plastic lens. 
 4. The solar yard alarm siren is very loud, never put the 
     unit close to your ear. 
 5. This unit should be directed away from extreme heat 
     sources. 
 6. If the unit goes off at random, it is possibly located   
     too close to a heat source, or located too close to 
     normal wanted activity. Changing the location or 
     direction of the unit may fix this problem.
 7. This unit can provide valuable protection for your home 
     or property if used properly. However, this unit cannot 
     guarantee complete protection against pool area entry 
     or burglary. Therefore, TECHKO will not be held 
     responsible for any loss or damages which could occur.
To install the unit:
(Fig.1) 
INTRODUCTION
FEATURES
IMPORTANT SAFETY TIPS
 8. Keep this operation manual in a convenient place
     for future reference.
INSTALLATION
Protect your yard and other important surrounding 
areas with the TECHKO Solar Yard Alarm & Garden 
light! Simply piece together and place firmly into the 
ground next to the desired area of protection. Let it 
charge, turn it on with the remote and you’re done ! 
Recharges daily by the sun. No batteries needed ! 
This unit can be placed in your yard, garden, pool area, 
or other areas in need of protection, while adding a 
decorative touch.
Solar Panel for Light
Solar Panel for Alarm
Garden Light
Alarm
LED Light
PIR Motion Sensor
Component Illustration 
Fig. 3
Flashing Alarm LED light
0
110
Fig. 4
0
90
The area of coverage provided by the unit  is 
0
 
 
approximately 90 degrees vertically and 110  degrees
horizontally with a range of approximately 23 feet 
from the unit. (Fig. 4)
For best coverage, this unit should be placed in a 
corner location to cover 7 meters (23 feet) outward.
Approximately 
Approximately 23 ft 
Approximately 
Before using, remove the plastic pull tab by 
pulling it down and out of its position. This
allows the internal batteries to now connect  
to solar power. (Fig.2)
When choosing the desired area of protection, make 
sure the area is wide open and that it is not placed 
behind bushes, hanging branches or similar moving 
shrub. This may cause confusion to the unit and set 
off false alarms.
ALARM
CHIME
OFF
Off
ALARM
CHIME
Solar panel
Remove before use
Fig. 2
Battery cover
Open solar panel and unscrew the battery 
cover (4 screws), and insert battery plug into 
connector. Replace cover and screws.