NorthStar Navigation EXPLORER 435 Manual Do Utilizador

Northstar Explorer 435/438 Installation and Operation Manual

8

The fishfinder is operated through menus.

1. Press   or    to move the highlight to the 

item.

2. Press   to select the item.

1.  Use the cursor keys    or    to make the 

change(s).

2.   Press    to confirm;    to cancel.

Power On / Auto Power

Press 

  to turn the fishfinder on.

If the fishfinder is wired for auto power, it turns 
on automatically whenever the boat’s ignition 

is turned on. This ensures that the engine hours 
counter and optional fuel functions are activated. 
A title display appears briefly. This is followed 
automatically by the Installation menu only the 
first time the fishfinder is switched on. Use this 
menu to specify the language (see section 3-1 Setup 
> System) and units (see section 3-7 Setup > Units).

At all other times, the title display is followed by 
the display that was used most recently. 

If the transducer is not connected, the message: 
No transducer detected. Enter 

simulate mode? will appear. Press    or    to 
select and press    to accept. (If the transducer 
was not intentionally disconnected, turn off 
the fishfinder and refer to the section on 
Troubleshooting in Appendix B.)

    

Returns to the previous menu / zooms in.

 ,    

Cursor keys move the selection highlight and

 

 

change settings / scrolls up or down.

     

Confirms changes / zooms out.

MENU   

Press to show the Display menu 

 

 

 

Press again to show the Setup menu.

+   Increases the Range.

Decreases the Range.

    Press and hold to power On and Off; pressing once shows  

 

the Gain controls. Press twice to show Backlight control.

Hold for Auto Range