Oricom WNS1 Manual Do Utilizador
- 6 -
RINGER ON/OFF SWITCH (A+T / OFF / T)
- A+T (alarm + telephone): for the alarm and telephone ring position.
- OFF: alarm and ring off.
- T (telephone): for the telephone ring position.
- OFF: alarm and ring off.
- T (telephone): for the telephone ring position.
HOW TO USE WITH YOUR TELEPHONE
- Ensure that your telephone is connected to the WNS1 as shown in the installation section.
- Select the ringer On/Off switch on the A+T or T position for the ring.
- Choose which of the alarm modes you wish to alert you of your incoming telephone calls (see
- Select the ringer On/Off switch on the A+T or T position for the ring.
- Choose which of the alarm modes you wish to alert you of your incoming telephone calls (see
page 5: V, V+S, S+F or F+V)
- When the alarm mode selected indicates there is an incoming telephone call, lift the telephone
handset and answer the call. When you have finished the call replace the handset and the
alarm will be ready to indicate the next call.
alarm will be ready to indicate the next call.
DIMMER SWITCH ( )
Adjust the brightness of the display by moving the control at the rear of your WNS1.
VOLUME CONTROL
Use this to set the volume of the ringer and the alarm sound.
TONE
This allows you to select the tone of the alarm sound that is best for you.
SHAKER SWITCH ( - / + )
Sets the motion of the shaker to Lo (-) or Hi (+)