Xantech Mouse 283M Folheto



1

The 283M Blink-IR Mouse Emitter contains a small Infrared LED housed in a miniature, mouse shaped,
black appearing, injection molded plastic shell.  Unlike other emitters, the 283M emits visible red light in
addition to IR (infrared) control signals when activated by IR commands sent to it by IR receivers or other
Xantech controllers.  The 283M is designed to be installed directly on the IR sensor window of the controlled
device.

7 FT

3 FT

9/16"

5/16"

3.5mm mono

mini plug

1/4"

Side View

Top View

NOTE: White striped
side is positive (+)

(–)

(+)

Clear adhesive
layer.
(Replace, if necessary,
with a short piece of the
2-sided tape supplied).

Mini-wire
lead

Emitter
Shell

IR & Red

Light

Output

IR & Red
Light Output
(Component Side)

• Each emitter has a clear adhesive layer on the bottom flat surface of the shell.  The rounded side faces

the user and emits visible red light when a command is sent (Fig. 2).

• Simply peel off the adhesive cover and affix the emitter to the center of the IR sensor window on the

controlled component's front panel.

• In some cases it may be difficult to find the location of the IR sensor on the component.  Consult the owner's

manual of the unit, or the manufacturer, for the exact IR sensor window location.

• Double-sided adhesive tape is included.  If you move the emitter to a different component, use this tape

to replace the current adhesive layer for best adhesion.

• The shell, though dark in appearance, is transparent to infrared light, allowing commands from a handheld

remote control to pass through it. This permits direct control of the equipment from a handheld remote as
well as from the 283M.